Chrysler Denso Engine Control Unit Information

MARSHALL ENGINES PREMIUM LONG BLOCK, REMANUFACTURED

Marshall Engines Remanufactured Premium Long Block Engines are built to the superior quality standards, assembled with precision and impeccable quality control, superior to rebuilt engines, and are shipped with the best warranty in the replacement engine industry. Completely remanufactured engine with all new wear parts, tight tolerances, and run-tested reliability.

Specifications:

• SOHC
• Front wheel drive

Features:

• 100 percent mag inspected and pressure tested, vacuum tested for perfect seal, decks milled and surface checked
• Supplied with adjusted valve train components, gasket set, new oil pump, 1 pulse air tube left-rear of block, and balance shaft elimination kit
• Bake cleaned and shot blasted cylinder heads
• Checked bend and journal polished to achieves perfect seal
• Installed camshafts, valves and springs, and 3-angled cut on valve seats
• Micro-polished design exceeding the original finish ensuring proper bearing lubrication and a final wash to ensure that crank is clean

Not supplied with jet valves.

Condition: Remanufactured

Quantity Sold: Sold individually

Part #: MEIC15625C

DENSO REGULAR CLASS OXYGEN SENSOR

Denso Regular Class Oxygen Sensors are specifically designed to meet the challenging demands of today's engines. Each of Denso's Oxygen Sensor is constructed from the highest quality materials available. Manufactured to the OE standards and subjected to rigorous safety and performance tests.

Specifications:

• 4-wire
• 11.77 in. lead wire
• Non-flanged

Features:

• Constructed from high quality stainless steel, porous polytetrafluoroethylene, fluorine rubber, aluminum oxide, high-grade platinum, and ceramics
• Double protection layer
• Aluminum oxide trap layer
• Porous PTFE filter
• Stainless steel housing

1 required per vehicle. Requires wire splicing and electrical installation. Reuse your old connector.

Location: After Catalytic Converter

Type: OE replacement, 4-wire

Quantity Sold: Sold individually

Warranty: 12-month Denso limited warranty

Part #: NP2344209

DENSO REGULAR CLASS OXYGEN SENSOR

Denso Regular Class Oxygen Sensors are specifically designed to meet the challenging demands of today's engines. Each of Denso's Oxygen Sensor is constructed from the highest quality materials available. Manufactured to the OE standards and subjected to rigorous safety and performance tests.

Specifications:

• 4-wire
• 11.77 in. lead wire
• Non-flanged

Features:

• Constructed from high quality stainless steel, porous polytetrafluoroethylene, fluorine rubber, aluminum oxide, high-grade platinum, and ceramics
• Double protection layer
• Aluminum oxide trap layer
• Porous PTFE filter
• Stainless steel housing

1 required per vehicle. Requires wire splicing and electrical installation. Reuse your old connector.

Location: Driver Side, After Catalytic Converter

Type: OE replacement, 4-wire

Quantity Sold: Sold individually

Warranty: 12-month Denso limited warranty

Part #: NP2344209

A1 CARDONE ENGINE CONTROL COMPUTER, REMANUFACTURED

A1 Cardone Engine Control Computers are designed to render durable and exceptional performance, control emissions, monitor, and regulate engine performance and fuel consumption.

Features:

• 100 percent resolder of critical components
• Superior electrical connections, no intermittent failures, and longer product life
• Corrects OE design flaw and ensures chips will not lift from the board causing the unit to fail
• Defective OE conformal coating is removed from the entire ECM board including underneath chips and replaced with upgraded conformal coating

Requires vehicle specific programming before installation.

Condition: Remanufactured

Quantity Sold: Sold individually

Part #: A1796026V

A1 CARDONE ENGINE CONTROL COMPUTER, REMANUFACTURED

A1 Cardone Engine Control Computers are designed to render durable and exceptional performance, control emissions, monitor, and regulate engine performance and fuel consumption.

Features:

• 100 percent resolder of critical components
• Superior electrical connections, no intermittent failures, and longer product life
• Corrects OE design flaw and ensures chips will not lift from the board causing the unit to fail
• Defective OE conformal coating is removed from the entire ECM board including underneath chips and replaced with upgraded conformal coating

Requires vehicle specific programming before installation.

Condition: Remanufactured

Quantity Sold: Sold individually

Part #: A1795423V

A1 CARDONE ENGINE CONTROL COMPUTER, REMANUFACTURED

A1 Cardone Engine Control Computers are designed to render durable and exceptional performance, control emissions, monitor, and regulate engine performance and fuel consumption.

Features:

• 100 percent resolder of critical components
• Superior electrical connections, no intermittent failures, and longer product life
• Corrects OE design flaw and ensures chips will not lift from the board causing the unit to fail
• Defective OE conformal coating is removed from the entire ECM board including underneath chips and replaced with upgraded conformal coating

Condition: Remanufactured

Quantity Sold: Sold individually

Part #: A1797204

ENGINE SPLASH SHIELD -- Made of high-density polyethylene for maximum durability and tensile strength; Built to exact OE dimensions for a precise fit; Backed by 1-year, unlimited-mileage warranty.

Location: Front

Material: Plastic

Quantity Sold: Sold individually

Warranty: 1-year, unlimited-mileage warranty

Part #: REPC310127

CYLINDER HEAD GASKET SET -- Does not include head bolts; A high quality, OE replacement cylinder head gasket set; Backed by 1-year, unlimited-mileage warranty.

Type: Cylinder head, OE replacement

Quantity Sold: Set

Warranty: 1-year, unlimited-mileage warranty

Part #: REPC312713

A1 CARDONE ENGINE CONTROL COMPUTER, REMANUFACTURED

A1 Cardone Engine Control Computers are designed to render durable and exceptional performance, control emissions, monitor, and regulate engine performance and fuel consumption.

Features:

• 100 percent resolder of critical components
• Superior electrical connections, no intermittent failures, and longer product life
• Corrects OE design flaw and ensures chips will not lift from the board causing the unit to fail
• Defective OE conformal coating is removed from the entire ECM board including underneath chips and replaced with upgraded conformal coating

Requires vehicle specific programming before installation.

Condition: Remanufactured

Quantity Sold: Sold individually

Part #: A1797400V

MALLORY HYFIRE 6AL DIGITAL CD IGNITION -- A High Output Multi-Spark Ignition System, Uses The Latest Microprocessor Controlled Circuitry In The Market, Provides Quicker Acceleration And Throttle Response, Gives More Performance And Lower Power Draw, Guarantees Digital Performance For The Price Of An Analog, With A Built-in, Easy-to-adjust Digital Rev Limiter From 4,500 to 12,000 RPM With No Chips Required, Has A Lightweight Aluminum Housing For Maximum Heat Transfer, Works With Points, OEM, Aftermarket Electronic Ignition, Or Magnetic Crank Triggers, Easy Installation, With Mallory's 1-Year Limited Warranty

Type: Universal product

Condition: New

Quantity Sold: Sold individually

Part #: M116853M