Plymouth Denso Piston Sets Information

DENSO REGULAR CLASS OXYGEN SENSOR

Denso Regular Class Oxygen Sensors are specifically designed to meet the challenging demands of today's engines. Each of Denso's Oxygen Sensor is constructed from the highest quality materials available. Manufactured to the OE standards and subjected to rigorous safety and performance tests.

Specifications:

• 4-wire
• 11.77 in. lead wire
• Non-flanged

Features:

• Constructed from high quality stainless steel, porous polytetrafluoroethylene, fluorine rubber, aluminum oxide, high-grade platinum, and ceramics
• Double protection layer
• Aluminum oxide trap layer
• Porous PTFE filter
• Stainless steel housing

1 required per vehicle. Requires wire splicing and electrical installation. Reuse your old connector.

Location: After Catalytic Converter

Type: OE replacement, 4-wire

Quantity Sold: Sold individually

Warranty: 12-month Denso limited warranty

Part #: NP2344209

DENSO REGULAR CLASS OXYGEN SENSOR

Denso Regular Class Oxygen Sensors are specifically designed to meet the challenging demands of today's engines. Each of Denso's Oxygen Sensor is constructed from the highest quality materials available. Manufactured to the OE standards and subjected to rigorous safety and performance tests.

Specifications:

• 4-wire
• 11.77 in. lead wire
• Non-flanged

Features:

• Constructed from high quality stainless steel, porous polytetrafluoroethylene, fluorine rubber, aluminum oxide, high-grade platinum, and ceramics
• Double protection layer
• Aluminum oxide trap layer
• Porous PTFE filter
• Stainless steel housing

1 required per vehicle. Requires wire splicing and electrical installation. Reuse your old connector.

Location: Before Catalytic Converter

Type: OE replacement, 4-wire

Quantity Sold: Sold individually

Warranty: 12-month Denso limited warranty

Part #: NP2344209

DENSO SUPER CLASS ALTERNATOR, NEW -- Precision designed and performance tested OE-standard quality alternator; Features a housing tapped to OEM specifications and damaged-checked for heat warping, corrosion or improper surface alignment; Has performance and insulation tested rotor and stator to 600 volts, packed bearing with OEM grade lubricant, up to 300 volts performance tested rectifier, and 100 percent stripped and replated hardware; Its slip ring is rematched to an average of 8 microns or 20 microns run-out maximum; With 12-month unlimited-mile Denso warranty.

Condition: New

Quantity Sold: Sold individually

Warranty: 12-month or unlimited-mile Denso limited warranty

Part #: NP2110105

DNJ PISTON RING SET -- 1.2 x 1.5 x 3.0 mm ring size; Features chrome rings that withstand new model engines with computer advancement and older engines; Designed and manufactured for quick seat and long life; With 12-month or 12,000-mile DNJ limited warranty.

Quantity Sold: Set

Warranty: 12-month or 12,000-mile DNJ limited warranty

Part #: DNJPR1150

DNJ ENGINE PISTON SET -- 1.5 x 1.5 x 4.0 in. ring size; Manufactured with associates who hold an ISO9002 or QS9000 certificate that is achieved only by meeting the highest of manufacturing standards; With 12-month or 12,000-mile DNJ limited warranty.

Quantity Sold: Set

Warranty: 12-month or 12,000-mile DNJ limited warranty

Part #: DNJP108

DENSO SUPER CLASS FIRST TIME FIT OXYGEN SENSOR

Denso Super Class First Time Fit Oxygen Sensors are specifically designed to meet the challenging demands of today's engines. Each of Denso's Oxygen Sensor is constructed from the highest quality materials available. Manufactured to the OE standards and subjected to rigorous safety and performance tests.

Specifications:

• 4-wire
• 22.8 in. lead wire

Features:

• Constructed from high quality stainless steel, porous polytetrafluoroethylene, fluorine rubber, aluminum oxide, high-grade platinum, and ceramics
• Double protection layer
• Aluminum oxide trap layer
• Porous PTFE filter
• Stainless steel housing

1 required per vehicle. This part does not require wire cutting.

Location: After Catalytic Converter

Type: OE replacement, 4-wire

Quantity Sold: Sold individually

Warranty: 12-month Denso limited warranty

Part #: NP2344076

DENSO REGULAR CLASS TRADITIONAL SPARK PLUG, SOLD INDIVIDUALLY -- 14 mm thread, 19 mm reach, 0.62 in. hex size, gasket seat, resistor type, solid terminal, projected tip, U-groove ground electrode, 0.044 in. gap, heat range 16; Designed with heavy duty insulator that provides unparalleled dielectric strength and thermal conductivity under extreme temperatures; Five-rib design prevents flashover while decreasing voltage loss; Copper glass seal bonds the center electrode and insulator together for a gas-tight seal; Platinum center electrode utilizes platinum to shrink the surface area of the center electrode tip for maximum firing performance and minimum voltage requirements; Platinum ground electrode resists gas and electrical erosion and corrosion extending service intervals to 60,000 miles.

Series: Denso Standard

Quantity Sold: Sold individually

Warranty: 12-month Denso limited warranty

Part #: NPK16PRU11

DENSO FIRST TIME FIT IGNITION WIRES, SET OF 8

Denso First Time Fit Ignition Wires are identical in form, fit, color, and performance to the factory-installed wire sets, and constructed to meet OE standards. Ferrite impregnated layers, silicone insulation for superior dielectric and heat performance, and high temperature Class E silicon jacket to withstand chemicals, moisture, and temperatures from -40 degrees Fahrenheit to 428 degrees Fahrenheit.

Specifications:

• 7 mm diameter

Features:

• Pre-cut wire to exact length with reinforcing member for added strength and terminal retention
• Passed tests covering everything from electrical properties to shrinkage to chemical resistance and accelerated life testing
• Identical OE end caps, carbon impregnated fiberglass core for superior conductivity, fiberglass braid for maximum strength, conductive silicone layer for high temperature performance, and EMI/RFI noise suppression

Easy installation.

Quantity Sold: Set of 8

Warranty: 12-month Denso limited warranty

Part #: NP6718119

DENSO PREMIUM CLASS DOUBLE PLATINUM SPARK PLUG, SOLD INDIVIDUALLY -- 14 mm thread, 19 mm reach, 13/16 in. hex size, gasket seat, non-resistor type, solid terminal, 0.032 in. gap size, 20 heat range; Designed with heavy duty insulator that provides unparalleled dielectric strength and thermal conductivity under extreme temperatures; The five-rib design prevents flashover while decreasing voltage loss; Its copper glass seal bonds the center electrode and insulator together for a gas-tight seal; Features a platinum center electrode that utilizes platinum to shrink the surface area of the center electrode tip for maximum firing performance and minimum voltage requirements; The platinum ground electrode resists gas and electrical erosion and corrosion extending service intervals to 60,000 miles.

Series: Denso Double Platinum

Quantity Sold: Sold individually

Warranty: 12-month Denso limited warranty

Part #: NP3229

LISLE PISTON RING INSTALLER -- Features tapered jaws to remove and install most passenger car and light truck rings from 3/64 to 1/4 in.; Comes skin-packed.

Quantity Sold: Sold individually

Part #: L1733500